DTMF reference
Most SvxLink-based nodes accept DTMF (touch-tones) on the air for repeater
status, the parrot module, EchoLink, and talkgroup selection. Send the
digits while keying up; tones marked with # need the terminator pressed
at the end of the sequence.
Substitute node_number and tg with the actual EchoLink node number or
talkgroup number you want to reach.
DTMF commands
| Command |
Description |
* |
Repeater status: ID, active module, talkgroup |
0* |
Full node status |
1 |
Activate the Parrot — send, terminate with # |
5 |
Weather for default airport (if installed) — terminate with # |
EchoLink commands
| Command |
Description |
2# |
Activate the EchoLink module (stage 1) |
node_number# |
Connect a distant node after stage 1 |
2#node_number# |
Activate EchoLink and connect a distant node in one step |
2* |
Announce connected EchoLink stations |
4 |
Reconnect last disconnected station |
2 |
Announce my EchoLink node number |
# |
Disconnect last connected node, or EchoLink itself if unconnected |
## |
Disconnect last node and the EchoLink module |
SvxLink talkgroup commands
| Command |
Description |
9* |
Talkgroup status |
91# |
Activate default talkgroup |
91 tg # |
Activate talkgroup tg |
910# |
Reset talkgroup to 0 (off) |
91222# |
Connect to Italy Wide |
91222121# |
Connect to Italy Canavese |
91222264# |
Connect to Italy Canavese multimode |
92# |
QSY to a random working channel |
93# |
Follow last QSY |
94 tg # |
Add talkgroup tg to the monitoring list |